Support Online

Sales PTC     
services@pitesvietnam.com
0918805949
Mr. Nhật     
nhat@pitesco.com
0909352877
Ms. Nguyệt     
elsa@pitesco.com
0918805949

Products & Services

1. Trade Representative:

Pites Co., Ltd is one of leading agencies in industrial automation components and equipments for various industry such as Power Plant, Cement, Steel, Glass, Automation, Oil &Gas, Food and Berverage, Chemcial, Packaging, etc

2. Import and Distribution:

Pites Co., Ltd specializes in importing and distributing of Factory Automation (all kind of sensors), Process Instruments( Temperature, Pressure, Level, Flow, Valves, pH and chemical measurements, control valves, Gas/Air Analyzer) Motion Control (Motor, controller, inverter, PLC, Encoder, Linear Sensor, Position Sensor), Industrial Safety parts ( relay, switch, fuse...,), Swith Gear.

3. Service:

Pites provides engineering services including design and install, commissioning, relocating, maintaince , training...for a variety of industries with participation and technical support from specilists of well- known brands in Germany, Italy, Switzerland, USA, Japan, India and Singapore...

Lượt truy cập

Đang online 1
Lượt truy cập 793246

Strain and Force Sensors AN1068, AN1068 Strain ring, Agent of Gefran

an1068-an1068-strain-ring-gefran-vietnam-dai-ly-gefran-vietnam.png

Strain and Force Sensors AN1068, AN1068 Strain ring, Agent of Gefran 

Overview

The strain ring AN1068 is based on the proven press-on technology of strain gages.

The strain ring presses strain gages under the stainless protective foil that strongly onto the surface to measured the friction.

It replaces the bonding normally used to fix strain gages, without calibration necessary.

Mounting: Clamp the strain ring with 2 screw‘s (torque of 3Nm) around the tie bar. Connect the cable for measurements. The surface at the measuring location should be free of any loose material (e.g. rust, paint etc).

The measuring location does not need to be chemically clean, just clean it with some solving agent.

The zero-offset of the pressed on strain gages after mounting is usually high.

Our amplifiers are able to handle this reset by the simple push of a button or a reset signal.

Description

  • Fast and easy strain measurement on cylinders (magnetic or not)
  • Very easy installation (need only 2 screw‘s)
  • 0.5% accuracy
  • Without calibration
  • All parts of the sensor are made in stainless materials.
  • Ideal for cyclical applications, e.g. clamping forcemeasurements on presses